User manual

APC-3x15 User Manual

Chapter 5 Touch Screen Installation

This chapter describes how to install drivers and other software that will allow your PenMount 5000

Controller Board (USB) to work with different operating systems.

NOTE: PenMount USB drivers support up to 15 USB controllers.

5.1 Introduction to Touch Screen Controller Board

The control board is configured for use with the USB interface. It connects to the touch screen, power

supply and computer system’s USB port, and supports 4-, 5- and 8-wire touch screens. The control

board has some advanced functions, such as PnP and non-PnP mode adjustable baud rate, thus

making easy for customers to select different touch screens without changing the control board. The

size of the board is 25 by 60mm, and it has two connectors and one dipswitch on-board.

Figure 5.1: Bird’s Eye View of Control Board

5.2 Windows Me/2000/XP USB Driver Installation for 5000 Boards

Before installing the Windows Me/2000/XP USB driver software, you must have the Windows

Me/2000/XP system installed and running on your computer. You must also have one of the following

PenMount USB controller boards installed: 5184 or 51A5. Contents of the PenMount Windows

Me/2000/XP USB driver folder are listed below.

Setup.exe

PenMount 98.inf

PenMount.inf

Pm_lower.sys

Pm_upper.sys

If you have an older version of the PenMount Windows Me/2000/XP USB driver installed in your