User manual

APC-3x15 User Manual
12
1.3 Installation of CD-ROM & HDD
There are 8 screws to deal with when
enclosing or removing the chassis.
Shown in the picture are the four
screws (as circled in red) that tighten or
loosen the bracket where the CD-ROM
is placed underneath. On top of the
bracket is where the HDD is placed. To
remove the CD-ROM, the HDD has to
be removed first.
Now slide the HDD into the bracket as
shown in the picture. After that, connect
the HDD to the 44-pin black IDE by
means of the cable, making sure the
red stripe of the cable is connected to
the pin 1 of the connector of the HDD
CD-ROM
Both of 2 at the right side