User manual

ADP-1XX8P User Manual

2.4 AD Board (VA-3600) OSD Functions

2.) Getting into Burn-in Mode

Before setting into a burn-in mode, first disconnect the AC power cord. Then press (don’t let them go)

the buttons until the AC power cord is connected and the “RGB” appears on the top left corner

of your screen. Now it can be put into the burn-in mode for changing colors.

2.) Getting Out of Burn-in Mode

Before getting out of the burn-in mode, please first disconnect the AC power cord. Then press the

button (If not workable, press the button and don’t let them go) until the AC power cord is

connected. Please don’t let your fingers go until the AC power cord is connected again and the

wording of “RGB” appears on the top left corner of your screen, and wait for 3 second. Under the

non-signal entry situation, if is seen, exit is thus successfully made.

When the Burn-in Mode is Unable to Eradicate…

4.) If the “RGB” is still on the top left corner of the screen, press to enter “Miscellaneous” and

choose “Reset”, and then Yes, and press . When the screen goes black, disconnect power and

repeat the above steps.

5.) If the “RGB” is not found, disconnect the AC power cord first. Then press the buttons

(don’t let them go) until the AC power cord is connected, and wait for 2 to 3 seconds. When

“RGB” appears, repeat the above steps.

6.) Functions of OSD Keys

Auto Adjust Up/Left Down/Right Power

Menu/Entry Power Indicator

Cable Not Connected