User manual
ADP-1190 User Manual
12
Chapter 3_____________________________
3.1 Optional Touch Screen Features
z RS-232 interface
z Touch controller is DMC9000
z Design for the best touch performance and easy configuration
z PnP or Non-PnP mode selectable
z Design for best cost arrangement
z Supporting 2048x2048 pen device resolution
z 19200 or 9600 baud rate transmission selectable
z Upgraded noise handling mechanism (3 level scheme)
z Fixed and high-speed sampling rate
z Touch screen cable, RS-232 with power cable connectors onboard
3.2 Windows 98/ME Driver Installation for 9036 Controller
Board
Before installing the Windows 98/ME driver software, you must have the Windows
98/ME system installed and running on your computer. You must also have the 9036
PenMount Serial Interface controller board installed. Contents of the PenMount
Windows 98/ME driver folder are listed below:
SETUP.EXE
DMC9000.INF
DMC9000.VXD
If you have an older version of the PenMount Windows 98/ME driver installed in your
system, please remove it first. Follow the steps below to install the PenMount Windows
98/Me driver.
1. When the system first detects the controller board, a screen appears that shows
“Unknown Device.” Do not use this hardware wizard. Press Cancel.