User's Manual

Last Revision: 6/9/2009 Copyright 2009 API Healthcare Corporation.
API Internal Document – Company Confidential Information
Page 3of 5
Figure 1.
2. Carefully pull the plastic spacer off the header at the end of the board, leaving the pins intact per Figure
2.
Figure 2.
3. Cut pins all the pins except 1, 3, 4, & 5 flush with the circuit board.
4. Tin the remaining pins with solder.
5. Solder the wires to the Indala header pins. Gently tug on each wire to ensure a strong mechanical joint.
Ensure there are no shorts between wires.
Indala Pin Wire Color
1 Red
5 Black
3 Yellow
4 Green
6. Insert two stand offs into the Indala board per Figure 3.