User's Manual

Last Revision: 5/11/2009 Copyright 2009 API Healthcare Corporation.
API Internal Document – Company Confidential Information
Page 3of 5
2. Solder the header into the pins shown in Figure 1 on the solder side of the Series 500 main PCB. It will
be necessary to slightly adjust the spacing of the pins. Note this header is used only for mechanical
fastening. There is no electrical connection.
3. Cut the free ends of the header to .1” length.
4. Place double sided foam at the location indicated in Figure 1.
Figure 1.
5. Place the module so the header pins line up with the mounting holes on the module.
6. Push the module down so that the foam tape secures the module.
7. Solder the two header pins to the solder pads on the module as shown in Figure 2.