User's Manual

Last Revision: 4/16/2010 Copyright 2009 API Healthcare Corporation.
API Internal Document – Company Confidential Information
Page 3of 5
Figure 1.
2. Insert the short pins of the two headers into the module. Note that the center hole is left empty. You
might need to bend the pins slightly to fit through the holes. Solder the pins. Use care not to damage the
antenna while soldering.
3. Remove the paper back and install a 1-1/4” X 1-3/4” plastic insulator over the circuit board.
Figure 2.
4. Trim the excess lengths of the pins and solder.