Specifications

Maxiva ULX Series
November 11, 2013
2‐17
888‐2628‐300 WARNING:Disconnectprimarypowerpriortoservicing.
Copyright©2013,HarrisBroadcast
2.9 SignalandGroundConnections
Note
Control and signal wires should never be run in the same conduit with any AC wiring. A separate conduit
should be used for control/signal cables.
STEP 1 Connectthevideo/audio(analog)ortransportstream(digital)andref erence
inputstothecustomerIOpanelatthetopofthetransmitter(see
Figure2‐7).
RefertothetablesbelowforexciterAandBconnectionswhichdifferfor
analoganddigitalapplications.
Figure 2-7 Customer I/O Panel (top of digital transmitter)
Table2‐5I/OpanelconnectionsforexciterA/B‐analog
Jack Connector Label
J1 SMA‐50 GPS(antenna)
J2 BNC‐50 1PPS
J3 BNC‐50 10MHZ
J4 BNC‐75 VIDEOIN
J5 BNC‐75 VIDEOAUX
J6 BNC‐75 AUDIOCOMP
J7 XLRConnector(female) AUDIOMAINL/R
J8 XLRConnector(female) AUDIOAUXL/R
MOV
Customer I/O
Panel
Coolant
Hoses
RF Out
AC Mains
Connect
Ground
MOV