Specifications

Maxiva ULX Series

November 11, 2013

2‐3

888‐2628‐300 WARNING:Disconnectprimarypowerpriortoservicing.

Ambienttemperatureandrelativehumidityshouldalwaysrangebetweenthefollowinglimitsatthecabinet

installationlocation:

• Ambienttemperature:0to+45

C.De‐rate2degreesCper300mAMSL.

• Relativehumidity:0to95%non‐condensing

Note

Failure to follow these installation instructions may void the warranty.

2.5 TransmitterCabinetPlacement

Thetransmittercabinetshouldbeplacedwhereitwillhaveapproximately1meterclearanceoneachsideandinthe

back.Thefrontofthetransmittershouldhaveaclearanceofatleast1.5meterstoallowaccessforremovaland

installationofthe PAmodules.Thereareseveraldrawingsincluded

inthedrawingpackagetohelpplanthecabinet

placement:

• OutlineDrawing

• RFEquipmentLayout

• LiquidCoolingSystemLayout

STEP 1 Removetheboltsorstrapsholdingthetransmittertothewoodenpalletand

carefullyslidethecabinetoffthepallet.

STEP 2 Removereardoorandsetasideinasafeplacefortherestoftheinstallation

process.

MULTI‐CABINETMODELS:

STEP 3 Placecabinetsinpositionandcarefullyalign.

ALLMODELS:

STEP 4 Uselevellingshimsundertransmittercabinetasrequiredtomakesurethe

transmitterislevelandsolid(notrocking).

STEP 5 InstallDripTray.Thealuminumdriptrayslidesunderthetransmitterjust

belowthereardoorpanel.Thedriptrayrestsonthefloorandiscentered

underneaththerearoftheMaxivatransmitter.Itshouldbechecked

periodicallyforpresenceofcoolant.

Note

Do not open the packaging for, or install IPA (driver), or PA modules at this time. These will be installed

just before the initial turn on.

2.6 RFSystemInstallation

RefertotheRFSystemLayoutdrawingandtoinstallationnotesin"2.3InstallationSequence"onpage2‐2.

RefertotheRFLayoutandElectricalInstallationdrawingsforPatchPanelconnections.

Caution

ALWAYS SHUT THE TRANSMITTER OFF BEFORE REMOVING COAX

PATCHES TO PREVENT POSSIBLE DAMAGE TO THE ANCHOR INSULATORS

(BULLETS).