Specifications

Maxiva ULX Series

November 11, 2013

a‐7

888‐2628‐300 WARNING:Disconnectprimarypowerpriortoservicing.

Figure a-8 Bevel Cut End and Remove Burs

Figure a-9 Torch Aiming Location

a.5 Cleaning The Soldered Joint

Vigorousscrubbingwithawirebrushandsteelwoolwillremovetorchblackwithgoodresults.Inaddition,cleaning

withanacidsolutioncanmakethisjobeasier.Theprocedureisasfollows:

Warning

MURIATIC ACID USED IN THE FOLLOWING PROCEDURE IS HAZARDOUS. USE

EYE AND SKIN PROTECTION WHEN HANDLING OR MIXING. KEEP AN EXTRA BOX

OF BAKING SODA HANDY FOR FIRST AID OR TO NEUTRALIZE SPILLS. PERFORM

THE PROCEDURES OUTDOORS IF POSSIBLE. IF THE WORK MUST BE DONE

INDOORS, WORK ONLY IN WELL VENTILATED AREA.

Warning

IN THE FOLLOWING MIXING PROCEDURE, ALWAYS PUT WATER IN THE CON-

TAINER FIRST AND THEN ADD ACID TO THE WATER. ADDING WATER TO A CON-

TAINER OF ACID MAY RESULT IN A VIOLENT & DANGEROUS REACTION.

1. Preparethreeplastic5gallonbucketsasfollows:

A. Bucket#1‐Water

B. Bucket#2‐Onequartmuriaticacidinfourgallonsofwater(SeeWarningsAbove)

C. Bucket#3‐Onepoundbakingsodainfivegallonsofwater

2. Aftersolderingisfinished,diptheendofthelineinthewatertocool.

3. Setthecooledendofthelineintotheacid‐watermixturefor5‐10minutes.Thiswillloosen

thefilmandbrightenthesilver.

4. Immersetheendofthelineintothesodasolution.Thiswillstoptheactionoftheacid.

5. UseaScotchBrightpadorsteelwooltoscrubofftheremainingtorchblack.

6. Ifthefluxscaleisparticularlystubbornrepeattheprocess.

7. Whenfinished,rinsethoroughlywhendonewithwateranddrythelinebeforeassembling.