Specifications

Maxiva ULX Series
November 11, 2013
5‐41
888‐2628‐300 WARNING:Disconnectprimarypowerpriortoservicing.
Copyright©2013,HarrisBroadcast
Caution
TCU CARDS ARE NOT HOT SWAPPABLE. THE TRANSMITTER SHOULD BE
OFF AND THE POWER DISCONNECTED FROM THE TCU BEFORE REMOVAL
OF CARDS.
STEP 2 UsethefingerholecutoutsbuiltintothesidesoftheTCUfrontpanelashandles,pull
outwardanddownonthefrontcover.
STEP 3 RemovefourrackmountingfastenersfromtheeachsidesoftheTCUfront.
STEP 4 PulltheTCUchassisoutoftherackasfarastheslidesallow.
Figure 5-35 TCU Slide Brackets
STEP 5 TheTCUcanbepivoteddownwardforeasieraccesstothecards.Thisisdoneby
removingthefrontscrew(shownin
figure5‐35)oneithersideoftheTCUslide
brackets.
Caution
THE TCU MUST BE SUPPORTED WHILE REMOVING THESE SCREWS TO
KEEP IT FROM FALLING DOWNWARD RAPIDLY.
STEP 6 RemovetheTCUcover.
Remove1screw
fromeachsideto
pivotTCUdown