AUTOMATION P R O D U C T S G R O U P, I N C. Operator’s Manual PG-2000 Automation Products Group, Inc. APG...Providing tailored solutions for measurement applications Tel: 1/888/525-7300 • Fax: 1/435/753-7490 • www.apgsensors.com • E-mail: sales@apgsensors.
PG-2000 Rev. A5, 11/08 Table of Contents Warranty ......................................................................................... 3 Instructions ..................................................................................... 4 Zero Trimming ............................................................................. 4 Battery Replacement (9 Volt Type) ............................................... 4 Re-Calibration .........................................................................
Rev. A5,11/08 PG-2000 • Warranty and Warranty Restrictions APG warrants its products to be free from defects of material and workmanship and will, without charge, replace or repair any equipment found defective upon inspection at its factory, provided the equipment has been returned, transportation prepaid, within 18 months from date of shipment from factory.
PG-2000 Rev. A5, 11/08 • Instructions All units are factory calibrated prior to shipment. NOTE: Due to the temperature sensitivity of the strain gages within the sensor, sudden temperature changes, such as holding an unmounted gauge by the sensor, will cause the readings on the display to fluctuate. Please install the gauge in your system before determining stability. 1.
Rev. A5,11/08 PG-2000 C. Re-check the zero and re-adjust the zero (“Z”) pot if required. D. Repeat steps B and C, until no further adjustment is required. 4. External Power: When equipped with this option, the gauge no longer operates from batteries, but instead is "externally" powered. The unit is powered via a miniature "Phone Jack" on the back of the unit. The "Tip" connection is the "+Power", and the "Center" is connected to the "-Power".
PG-2000 Rev. A4, 11/08 Notes Automation Products Group, Inc. APG...Providing tailored solutions for measurement applications 6 Tel: 1/888/525-7300 • Fax: 1/435/753-7490 • www.apgsensors.com • sales@apgsensors.
Rev. A5, 11/08 PG-2000 Notes Automation Products Group, Inc. APG...Providing tailored solutions for measurement applications Tel: 1/888/525-7300 • Fax: 1/435/753-7490 • www.apgsensors.com • sales@apgsensors.
AUTOMATION P R O D U C T S G R O U P, I N C. APG...Providing tailored solutions for measurement applications Automation Products Group, Inc. Tel: 1/888/525-7300 1/435/753-7300 Fax: 1/435/753-7490 e-mail: sales@apgsensors.com www.apgsensors.com Automation Products Group, Inc. 1025 W. 1700 N. Logan, UT 84321 To order additional copies of this manual, ask for APG part number PN9000040 Rev.
