user manual

Rev. B, 1/12 LOE Series
9
Automation Products Group, Inc.
APG...Providing tailored solutions for measurement applications
Tel: [phone] • Fax: [phone] • www.apgsensors.com • [e-mail]
Sensor Setup via DHCP (automa c IP confi gura on)
Connect the LOE to a network that provides access to the internet, and apply
power to the sensor. The COM LED should begin to fl ash once every 30
seconds, indica ng the DHCP is a emp ng to establish communica on with the
web site. Once communica on is established, the COM LED will illuminated.
NOTE: see Troubleshoo ng DHCP if COM LED con nues to fl ash from more than
2-3 minutes.
Accessing the Internal Web Pages
To access the sensor’s se ngs, open an Internet browser, and in the address
bar enter: loe_# where # is the sensor’s serial number beginning at the
fi rst whole number. For example if the serial number is L000001275, then
you would enter loe_1275 into the browser address bar. The following screen
should appear:
NOTE: if typing the loe_# does not work, it may indicate the DHCP has saved
a previous name for the IP assigned. Power down the sensor and have the
System Administrator delete this name from the DHCP server.
Next, click the “Home” bu on and use the following default login when
prompted:
Username: admin Password: password
NOTE: use the Security link on the main page to set the desired Username
and Password.