User manual

E UTILITY PAGES E.3 Current Ethernet IP Address
E.3 Current Ethernet IP Address
U
IP
Curr
192.168 0
123
This may be viewed in The IP Curr page of the UTIL menu. This value cannot be edited.
E.4 IP Mode
The Ethernet IP address may be automatic Auto or may be a fixed static value Static as
determined by the IP Mode page of the UTIL menu.
Warning Do NOT use Static mode unless your IT system specifically requires it. Auto mode
should always be used where possible since in this mode, the DMS48 device can always be
discovered by the PWAPG application. When in Static mode, a warning will flash on the
Default screen.
Also see Ethernet on the next page.
E.5 IP Static
This allows the Static Ethernet IP address to be adjusted by the three rotary encoders the the
IP Static page of the UTIL menu. This will only have effect when in Static mode.
E.6 Store Snapshot
This page of the UTIL menu allows a Snapshot to be defined.
Also see Snapshots on the following page.
E.7 Recall Snapshot
This page of the UTIL menu allows a Snapshot to be recalled.
Also see Snapshots on the next page.
E.8 Bandwidth Units
This page of the UTIL menu allows the Bandwidth of Parametric Equalisers to be viewed and
adjusted in either Octaves or Q.
E.9 Latency display
This page displays the latency induced by signal processing in the device. This latency value
is computed, and not directly measured. It also does not take into account the additionnal
delays, added either by the user or by APG factory presets.
Also see Latency Delays on page 25.
User Manual DMS48 V1.1 23