user manual Instruction Manual

Rev. A1, 2/14 DCR-1006A Ultrasonic Controller
15
Automaon Products Group, Inc.
APG...Providing tailored soluons for measurement applicaons
Tel: [phone] • Fax: [phone] • www.apgsensors.com • [e-mail]
UNITS:
Determines the unit of measure for the Calculated Reading when in
Applicaon Types 1, 2 or 7 (see below).
bACK L (Back Light):
Allows the user to adjust the intensity of the display backlight. There are 9 set-
ngs from o to 100% intensity.
CUSTOM (Custom Units):
Allows the user to dene a custom alphanumeric label for the Curve Fit and
Linear Calculaon Applicaon Types.
VOLUNI (Volume Units):
Determines the unit of measure for the volumetric Applicaon Types. Opons:
Cubic Feet, Million Cubic Feet, Gallons, Cubic Meters, Liters, Cubic Inches, Bar-
rels.
IN SEL (Input Select):
Selects the sensor input used by the controller.
DST: Standard DST sensor
LR DST: Long Range DST (DST-3434)
MNU: MNU sensor (via “RS-485 Sensor” input)
dECIML (Decimal Place):
Sets the number of decimal places included in the sensor reading.
Example: a reading of 26.573 (feet, gallons, etc.) will be displayed as follows:
Decimal Place = 0 Volume = 27
Decimal Place = 1 Volume = 26.6
Decimal Place = 2 Volume = 26.57
Decimal Place = 3 Volume = 26.573
SENS N (Sensor Number):
Sets the Modbus address number for the DCR-1006A when its interfacing with
an RST-5002 module or the APG Modbus soware.