user manual Instruction Manual

DCR-1006A Ultrasonic Controller Rev. A1, 2/14
12
Automaon Products Group, Inc.
APG...Providing tailored soluons for measurement applicaons
Tel: [phone] • Fax: [phone] • www.apgsensors.com • [e-mail]
• Programming
The DCR-1006A can be programmed using the on-board push buons or by
using the RS-485 NET interface to communicate with APG’s Modbus soware or
RST-5002 communicaons module.
Push Buon Funcons:
ENTER
Opens the programming menu, selects menu opons, accepts parameter set-
ngs, and steps le one digit within any numeric sengs.
NOTE: In order to save changes to a parameter seng, the ENTER buon
must be used to exit the seng.
BACK
Steps back (upward) one level within the menu. Steps right one digit within any
numeric parameter seng.
NOTE: Exing a parameter seng using the BACK buon will not save any
changes made to seng.
UP and DOWN
Used to cycle through the opons within each menu level or to increase or
decrease the value of the ashing digit within a numeric seng.