Installation guide

2
Step 1: Hardware Installation
1. Install the antenna.
2. Plug in the right power supply.
3. Connect your camera to the wireless router (Modem or Switcher) with net cable.
Screw the antenna to the back of the camera; Make sure it is attached securely.Connect your
camera to the router, modem or switcher with net cable. Plug in the power. After a while, the
yellow network light at the rear of the camera will blink and the camera will pan and tilt
automatically. The green power light will keep on.( If off, said the search network fails, pls
check the network cable is correctly used)