User Manual

8 | P a g e
STEP 3
Use Screw A to secure two upper supports to the beam.
STEP 4 (Mounting matching top from us)
Lay the table top on a soft and non-abrasive surface. Carefully move the underframe onto the top, align the
holes on the upper supports to the pre-drilled anchors on the top. Secure the top with Screw A. Don’t over-
tighten the screws.
Use longer Screw F1 to mount non-memory controller, and shorter Screw F2 for memory controller. If F1 Screw
is used to mount memory controller, it will go thru the top. Please note that pre-drilled holes are only available
on the right side. Non-memory controller looks identical on both sides. The upper side of non-memory
controller is labeled “Attach this side to tabletop”.