User Manual

7 | P a g e
STEP 2
Remove the protective cap and insert the hexagon spindle into gear box on the beam. Please note the marking
R and L on the beam and legs. Right leg should connect to right side of the beam, and left leg to left side of the
beam.
VERY IMPORTANT:
Minor adjustment to the spindle head may be needed to set it properly into gearbox. Use a tool like a wrench to
turn the spindle head slightly left or right if needed. If you have tested the motor before attaching both legs,
make sure to set the motor to the lowest position before attaching legs. Limited range will happen if motor and
legs are not set the lowest position, and not “on the same page”. Refer to trouble-shooting section for more
info if limited range occurs.
TIP: Attach leg one at a time. Some users find it easier to attach legs by doing the opposite of what is illustrated
below. Place the beam upside down on the floor exposing the female socket of the gearbox and push spindle
head into the gearbox while turning the leg slightly left and right. Please remember to turn the assembled
frame over to its upright position before securing the legs to the beam. The screws should be in from beam-
side.
Remove protective cap
Don’t force
hexagon spindle
into gear box. If it
does not go all
way down, adjust
spindle by turning
it slightly.
Don’t put extra
pressure on spindle
and lifting column