Installation Manual

6 | Page
STEP 2
Remove the protective cap and insert the hexagon spindle into gear box on the beam. Please note the marking
R and L on the beam and legs. Right leg should connect to right side of the beam, and left leg to left side of the
beam.
VERY IMPORTANT:
Minor adjustment may be needed to set the hexagon spindle properly into gear box. Put the protective cap
back on the hexagon spindle and turn the cap with a tool to make necessary adjustment.
Remove protective cap
Don’t force
hexagon spindle
into gear box. If it
does not go all
way down, adjust
spindle to assign
properly.
Don’t put extra
pressure on spindle
and lifting column