Installation Manual

5 | Page
ASSEMBLY INSTRUCTIONS
BEFORE YOU BEGIN
1. Lay out all components and hardware to ensure that you have all the parts listed on the parts page.
2. Desk weighs close to 100 lbs. Two people are needed to turn or move desktop and some of its
components. When turning or moving the assembled desk, grab it BY UPPER SUPPORTS (not the
desktop).
3. Assemble on soft surface or cushion to avoid scratch or damage to the desktop.
STEP 1
Lay the lower support (foot) flat on the floor and secure it to the leg with Screw E as illustrated below. Make
sure to use longer socket-headed Screw E not shorter dome-headed Screw A.
The foot is hollow. In an unlikely event that a screw or washer falls into the foot, you can get it out by
unscrewing the leveling stud and prying open the plastic ender with a flat screw driver. You may also choose
not to do anything as two extra screws are provided.