Installation Manual

10 | Page
TROUBLESHOOTING
Problem(s)
Solution
Desk is unsteady.
All standing desks have some degree of unsteadiness at
standing height especially on a hard surface like tile floor.
Adjust leveling stud, or put a rug under it if necessary.
Check all screws and make sure they are all tight.
Desk does not go up or down. Check all connections. Make sure controller box is plugged
into a power outlet and controller is plugged into control
box.
Desk goes up or down unevenly.
Unplug the power from the source to reset controller. If
the problem persists, send an email to
[e-mail].
CARE INSTRUCTIONS
Recommend checking the screws and bolts several times a year to ensure they stay tight.
For all surfaces: wipe clean with a damp cloth and a weak cleaning solution, then dry with a clean and dry cloth.
TECHNICAL SPECIFICATIONS
Height Range 27.56” – 45.67” (without top)
Lifting Speed 0.5” per second
Load Capacity 170 lbs
Input Power 110V, 2A, 50Hz
Duty Cycle Max 4 min. ON / 18 min. OFF