ELECTRIC HEIGHT-ADJUSTED SIT TO STAND DESK Vortex Series Assembly Guide For Desk with Underframe Model No.
Table of Contents CAUTION, USE & LIABILITY .......................................................................................................................... 3 PARTS & HARDWARE ..................................................................................................................................... 4 ASSEMBLY INSTRUCTIONS ........................................................................................................................ 5 CARE INSTRUCTIONS ............................
CAUTION, USE & LIABILITY CAUTION Make sure no obstacles are in the desk’s path. Make sure the desktop is not touching any walls. Make sure all cords are appropriate lengths to accommodate the change in desk height. Keep children away from electric sit to stand desks, control units and handsets. Keep all electrical components away from liquids. Do not sit or stand on the desk frame. Do not crawl or lie under the desk frame. Do not place any objects taller than 20” underneath the desk.
PARTS & HARDWARE PARTS DIAGRAM Upper Support Tabletop Controller Leg Foot PARTS LIST Foot (2) Leg (2) Beam (1) Controller (1) Upper Support (2) (For Memory Controller) HARDWARE LIST ST2.
ASSEMBLY INSTRUCTIONS BEFORE YOU BEGIN 1. Lay out all components and hardware to ensure that you have all the parts listed on the parts page. 2. Desk weighs close to 100 lbs. Two people are needed to turn or move desktop and some of its components. When turning or moving the assembled desk, grab it BY UPPER SUPPORTS (not the desktop). 3. Assemble on soft surface or cushion to avoid scratch or damage to the desktop.
STEP 2 Remove the protective cap and insert the hexagon spindle into gear box on the beam. Please note the marking R and L on the beam and legs. Right leg should connect to right side of the beam, and left leg to left side of the beam. VERY IMPORTANT: Minor adjustment may be needed to set the hexagon spindle properly into gear box. Put the protective cap back on the hexagon spindle and turn the cap with a tool to make necessary adjustment. Remove protective cap Don’t force hexagon spindle into gear box.
STEP 3 Use Screw A to secure two upper supports to the beam. STEP 4 Use Screw A to secure top and Screw F1 to secure controller.
STEP 4-1 (Memory Controller Option) Use Screw A to secure top and Screw F2 to secure controller. STEP 5 Connect controller to the control box. Connect power to a wall plug. If the desk is unsteady, check all screws and make sure they are all tight, and make adjustment to the leveling studs. Please not that minor unsteadiness is common for all standing desks at standing height especially when it is on a hard surface like hardwood floor.
Memory Function Controller for Desk Underframe Model# AL4628-2M Preset 1 Preset 2 Preset 3 Preset 4 LED Display Up Button Down Button a. LED panel displays minimum height of 28.5” and maximum height of 46.6” b. Factory default settings for four memory buttons are 32.1”, 35.7”, 39.3” and 42.9” respectively. c. To set your own height, press up or down button until the desk reaches the desired height, press and hold memory button until you hear two beeps.
TROUBLESHOOTING Problem(s) Desk is unsteady. Solution All standing desks have some degree of unsteadiness at standing height especially on a hard surface like tile floor. Adjust leveling stud, or put a rug under it if necessary. Check all screws and make sure they are all tight. Check all connections. Make sure controller box is plugged into a power outlet and controller is plugged into control box. Unplug the power from the source to reset controller.
WARRANTY INFORMATION SCOPE OF WARRANTY Apex Furniture LLC (“ApexDesk”) warrants to the original purchaser its new desk (except for components not warranted under “Exclusions”) manufactured by ApexDesk to be free from defects in material and workmanship under normal use and service.
