User Manual

STEP 3A: MOUNTING DESK TOP (with matching top from us)
Place desk top on a flat and non-abrasive surface with holes facing up. Carefully place assembled frame onto
the desk top. The frame is heavy. Two people are needed to move it and to turn the desk over after it is
assembled. Align the holes on the support brackets to those pre-installed anchors on the desk top if you are
using the matching top from us. Insert 3 machine screws (E5) into the mounting holes of each Support Bracket
and only tighten them HALF-WAY.
1. Make adjustment to the two connecting bars in the mid-section of the beam by sliding them to the left or
right and make sure to center two mounting holes on the bars. Tighten 8 set screws (E3) that you installed
in Step 2, and all 6 machine screws (E5) for the Support Bracket.
2. Use 2 wood screws (E2) to secure the Height Controller to the desk top edge. Please note that pilot holes
are only pre-drilled on the right side.
3. Use 3 wood screws (E2) to mount Control Box on the back side of the top. Three pilot holes are pre-drilled
in the mid-section behind the beam.
4. Use 4 wood screws (E2) to mount Cable Management Tray.
5. Optional: use 2 to 4 wood screws (E2) to secure two connecting bars to the top. Most users forgo this
step.
STEP 3B: MOUNTING DESK TOP (with your own top)
1. Place the frame in the center of your own top and make adjustment to connecting bars. For best stability,
the frame should be centered with Support Brackets about 2” from the edge.
2. Use provided Wood Screws to secure the frame to your own top. If you are using own screws, please check
the length and make sure they do not go through the top.
3. Follow 1 to 5 under STEP 3A.
Flex Pro Series Assembly Guide 6 | Page