User Manual

Elite Series Assembly Guide 9 | P a g e
STEP 6
Now that you have completed the assembly of underframe, it is a good idea to initialize the desk and make sure
everything works before assembling the top to the underframe. Turn the underframe over to upright position.
1. Connect height controller cable to the left plug on control box.
2. Connect motor cables to control box. Motor cables can be connected to either port and
interchangeably. Switching cables from one port to another may be needed when trouble-shooting.
Please refer to trouble-shooting section for details.
3. Plug power cord to control box.
4. Plug power cord to a power outlet
STEP 7: INITIALIZING DESK WITH 2-BUTTON CONTROLLER
DESK MUST BE INITIALIZED BEFORE YOUR FIRST USE, and may need to be re-initialized (reset) from time to
time to work properly. Please note resetting requires more than just a simple power-off and power-on. Use
Height Controller to initialize/reset.
Press and hold UP and DOWN arrow buttons for three seconds and then release both buttons. The desk will
first go to the lowest position, then the highest position and finally stops in between. The buttons are not
designed to be super-sensitive. You will need to press HARD in the center of the buttons. Your desk is ready to
use once this process is completed.