User Manual

Elite Series Assembly Guide 10 | P a g e
STEP 7-A: INITIALIZING DESK WITH MEMORY CONTROLLER
DESK MUST BE INITIALIZED BEFORE YOUR FIRST USE, and may need to be re-initialized (reset) from time to
time to work properly. Please note resetting requires more than just a simple power-off and power-on. Use
Height Controller to initialize/reset.
Press and hold UP and DOWN arrow buttons until blinking 000 appears on the display, and then release the
buttons. The desk will first go to the lowest position, then the highest position and finally stops in between. The
initialization is complete when number 38 (+/- 1) appears on the display. Your desk is now ready to use.
You can preset up to four positions. Use UP and DOWN arrow buttons to move desk to your desired position.
Press M and one of the number buttons together for 1 to 3 seconds until displayed height starts
blinking, and then release the buttons. To go to your preset height, simply press the number button
TWICE or press and hold the button.
STEP 8
This step is a two-person job. Carefully move the assembled frame onto desk top.
Align the holes on the support brackets to those pre-installed anchors on the top. Secure each side with three
Screw A (M6x16mm). Use a Philips screwdriver to secure controller to the pre-drilled holes on the bottom of
the top with two Screw E (ST4.8x7mm).
Adjust leveling studs on the feet. Make sure the stubs make solid contact with the floor.