Owner's Manual

Specification
Low frequency limit:- 27Hz (EQ1) 21Hz (EQ2)
Upper frequency limit:- 40 – 120 Hz Variable
Low pass filter alignment:- Active 4th order 24db/octave (two-stage filter)
Cabinet Specification: - Sealed Cabinet of 25mm M.D.F construction with internal bracing
Amplifier Output:- 500 Watts (RMS) 1000 Watts (Peak)
Amplifier classification:- Class- D Digital amplifier
Driver compliment:- 1 x 12” C-CAM
®
subwoofer driver featuring triple suspension and 3”
long throw voice coil
Dimensions:- Millimetres:- 340 x 340 x 370
(H x W x D) Inches:- 13
3
/
8
x 13
3
/
8
x 14 ½
Weight (unpacked):- 25.5 Kg (56lbs)
Input Impedance: - 20K Ohms
Mains input voltage:- 110 - 120 Vac / 220 - 240 Vac 50/60Hz
(Electronically Auto selected)
C-CAM® is a registered trade mark of Monitor Audio Ltd
Trouble Shooting
Should you experience any technical, or set-up problems with your AW-12 please check the Trouble Shooting
Guide below:
My AW-12 will not turn on/no power.
•฀ Is฀the฀LED฀illuminated฀on฀the฀back฀of฀the฀unit?฀฀If฀not,฀then฀check฀your฀mains฀lead฀is฀properly฀connected฀
both at the AW-12 and at the mains outlet. Also check the fuse of the mains plug (where fitted) and also
the fuse in the AW-12. See page 7 for further information on changing the fuse and it’s location.
•฀ Is฀the฀LED฀on฀the฀back฀red?฀฀If฀so,฀you฀have฀power฀going฀to฀the฀unit.฀฀It฀could฀be฀that฀there฀is฀no฀signal,฀
or the 12v trigger is connected and the source not turned on (see below).
•฀ Have฀you฀got฀the฀12v฀trigger฀connected?฀฀If฀so,฀the฀AW-12฀will฀not฀power฀up฀until฀the฀source฀is฀powered฀
up.
•฀ Has฀it฀got฀a฀signal฀going฀to฀it฀(12v฀trigger฀not฀being฀used)?฀฀If฀so,฀is฀the฀Power฀Mode฀Switch฀in฀the฀Auto฀
or฀On฀position,฀and฀the฀signal฀source฀is฀turned฀on?฀฀Try฀adjusting฀the฀volume฀level฀of฀the฀source.
If it still does not turn on/ power up, please contact your local dealer/ distributor or Monitor Audio immediately.
No sound from AW-12.
•฀ Is฀the฀LED฀on฀the฀back฀red฀or฀green?฀฀If฀it฀is฀red,฀then฀the฀unit฀hasn’t฀actually฀turned฀on.฀฀See฀above฀
comments. If it is green, then your unit is powered up and turned on. Check further suggestions
below.
•฀ Are฀the฀signal฀leads฀connected฀correctly?฀฀Check฀these.฀฀If฀possible,฀check฀with฀a฀second,฀known฀to฀be฀
working set.
•฀ Is฀the฀volume฀level฀just฀very฀low?
If it still does not output a signal, please contact your local dealer/ distributor or Monitor Audio immediately.
monitoraudio.co.uk
9