Manual

Instruction Manual ]

ADDITIONAL FEATURES

Programming the Remote Control l

1.Set the TV, DVD/VCR, SAT/CAB, AUX switch to the device you want to control

2.To program the remote control

1)Press and hold the SET key for over 3 seconds until the LED indicatoron the remote control turns off. Release the key

and the LED will light again. The remote control is now in the PROGRAMMING mode.

2)Use the 0-9 keys to enter three-digit code number for your device. If the right code number was entered, the LED blinks

three times. If you enter a code not listed below, or you press any other keys than STANDBY and ENTER, the LED

turns off.

3)"TV": To control TV. "DVD/VCR": To control DVD, VCR, LD and CD. "SAT/CAB": To control satellite receiver

and cable box. "AUX": To controlallthe above appliances

3.To search codes

1)Press and hold the SET key for over 3 seconds until the LED indicator on the remote control turns off. Release the key

and the LED will light again. The remote control is now in the PROGRAMMING mode.

2)Press the STANDBY key and code search begins.

Press Description

The remote control searches codes upwards or downwards. Each time you press the up or

Up or down down arrow key, the code numberfor the STANDBY key increases or decreases by 1; or the

code number automatically increases or decreases by 1 per 3 seconds. Try each code

arrowkey separately until you find the one that works. If not after trying all the codes, LED blinksrapidly

eighttimes and search stops.

ENTER Ifthe desired code numberisfound, pressthe ENTER key to confirmthecurrentsearched code

numberfor yourdevice. Then LED blinksrapidlythree times to exit from search.

Other keys LED blinks rapidlyeighttimes and searchstops.

4)When the TV, DVD/VCR, SAT/CAB, AUX switchisset tothe "AUX" position,the remotecontrolcan not search

code.

4.To check the current code number

1)Press and hold the SET key for over 3 seconds until the LED indicatoron the remote control turnsoff. Release

the key and the LED will light again. The remote control is now in the PROGRAMMING mode.

2)Press the ENTER key.

3)You may read the code number according to the LED display status as follows.

Code Number LED Display Status

First-digit Second-digit Third-digit First-digit Second-digit Third-digit

0 0 0 Blinks rapidly once Blinks rapidly once Blinks rapidly once

1 0 6 Blinks once Blinks rapidly once Blinks six times

0 4 3 Blinks rapidly once Blinks four times Blinks three times

1 5 0 Blinks once Blinks five times Blinks rapidly once

5.To use the REC key

The REC key functions only when it is pressed twice continuously.