Product Manual B

When the generator runs out of water, the Red (Out of Water) Light (G) will illuminate and beep, indicating low water.
A: SWITCH THE ON/OFF SWITCH (E) TO THE OFF “ - ” POSITION
• The amber LED inside the ON/OFF Switch (E) will turn off, indicating that the generator is no longer heating.
B: CONTINUE USING STEAM UNTIL ALL THE PRESSURE IS GONE
C: UNPLUG THE POWER CORD FROM THE 120V 3-PRONG OUTLET
• To continue cleaning, go back to steps 1-5 listed above.
Quick Guide for Refilling the Generator
A: SWITCH THE ON/OFF SWITCH (E) TO THE OFF “ - ” POSITION
• The amber LED inside the ON/OFF Switch (E) will turn off, indicating that the generator is no longer heating.
A: CONTINUE USING STEAM UNTIL ALL THE PRESSURE IS GONE
B: UNPLUG THE POWER CORD FROM THE 120V 3-PRONG OUTLET
C: LET COOL COMPLETELY, WIND POWER CORD, AND STORE IN A DRY PLACE
WARNING: Follow all weekly and monthly maintenance steps described in the manual.
OR: When Finished Cleaning
Quick Guide for Filling & Heating
QUICK START-UP GUIDE
1: FILL WITH FRESH TAP WATER
WARNING: TAP WATER ONLY
• Fill the ller bottle with water.
• Push down and twist to unscrew the pressure cap (A).
• Insert the tip of the ller bottle into the pressure cap
opening and push down.
• After lling (takes two bottles of water), reinstall cap.
2: ATTACH THE STEAM HOSE/WAND
• Lift open the safety cover on the Steam Gun Socket (B).
• Insert the steam gun plug into the open socket.
• Gently pull the steam gun plug to ensure that it is
securely in place.
3: PLUG THE POWER CORD (C) INTO A
3-PRONG OUTLET - 120VAC, 15AMP
WARNING: If an extension cord is used, it must be
3-prong with ground, at least 12AWG, and NO longer than 25ft
• The Green (Power) Light (D) will illuminate, indicating that the generator is active.
4: SWITCH THE ON/OFF SWITCH (E) TO THE ON (“O”) POSITION
• An amber LED inside the ON/OFF Switch (E) will illuminate, indicating that the generator is heating up.
• After approximately 12-14 minutes, the unit will be up to maximum pressure and the Green (Ready) Light (F) will be illuminate.
5: BLEED THE STEAM LINE BEFORE USE
• Point the Steam Gun in a safe direction and hold both pressure switches on the steam gun for about 30 seconds and then release.
• Allow the Green (Ready) Light (F) to illuminate again, NOW THE GENERATOR IS READY TO USE.
A
E
G
F
D
B
C
APEX Steam™ Technologies
A Division of Pemberton Fabricators Inc.
P.O. Box 227
30 Indel Avenue
Rancocas, NJ 08073
Phone: [phone]
Fax: [phone]
www.apexsteam.com
[e-mail]
TM
DIV ISION OF PEMBERTON FABRICA TORS INC.
rev. 03012017