Instructions / Assembly
Page 3Rev. 030620
1-888-651-3431
Step 1. Connect the carrier base (A) and top frame (B) using the large plate supports (F), medium
plate supports (G), small plate supports (H), reector plate supports (I), and M5x10 Phillips head bolts
and nuts (P). Tighten with an 8mm wrench and Phillips screwdriver.
Tip: Lay out all plates in the correct positions before starting. Attach four corner plates rst to help
stabilize the assembly. When attaching a plate, hand-tighten all bolts rst, then tighten securely.
Step 2. Carefully ip over the basket assembly. Attach the hitch bar (D) to the bottom of the base
using the M6x45 bolts, washers, and nuts (O). Tighten securely using a 4mm Allen wrench and 10mm
wrench. Turn the assembly right-side-up.
Tip: Make sure the hitch bar is facing correctly, with the hitch tube extending out towards the vehicle
end.
Assembly
(1a)
(2a) (2b)
(2c)
(1b)