Owners manual

DRAIN CLAMP INSTALLATION POSITIONING THE SYSTEM

1) The drain clamp assembly should be installed above

the trap and on the vertical or horizontal tailpiece (Fig. #5)

1) The head assembly will stand up in the sink cabinet

or can be hung on screws provided.

2) The storage tan k may be laid on its side.

3)The head assembly and/or storage tank maybe

placed up to 15 feet from the point of use with nominal

pressure loss.

2) Mark the hole position on the pipe and drill a ¼” hole

through one side of the pipe (Fig. #6).

CONNECTING THE SYSTEM

1) Compression fittings may be found on the water supply

adapter and the faucet. To make the connections, slide a

compression nut onto the tubing (Fig. #8), slip a white

plastic sleeve onto the tubing with the beveled end

towards the end of the tubing, insert a brass insert into the

tubing, bottom the tubing into the fitting, slide the nut up

and tighten with a wrench. DO NOT OVER TIGHTEN.

NOTE: Do not use brass sleeves on plastic tubing,

use only plastic sleeves on plastic tubing.

3) Make sure to align drain saddle to drilled hole. Attach

drain clamp to drain pipe and tighten the two screws

evenly (Fig #7). NOTE: The center hole on the sponge

must be removed.

4) Connect the red tubing to the drain clamp.

1) The plastic fitting on the drain clamp is connected by

slipping the plastic nut onto the tubing, insert brass or

plastic insert into the tubing, bottom the tubing into the

fitting and tighten finger tight.

2) Use the color coded tubing to make the following

connections:

A) The tubing connects the water supply adapter to

the first clear housing of the head assembly.

B) The tubing connects the faucet to the outlet side

of the post carbon.

C) The tubing connects the storage tank to the inlet

side of the post carbon.

D) The tubing connects the drain clamp to the R/O

membrane.