User manual

UNPACK THE ARGOS

The following should be included with each ARGOS system :

1x ARGOS

1x Microphone

1x Power cord

1x This manual

INSTALLATION

• The ARGOS may be rack-mounted or free-standing.

• The ARGOS will accept voltages from 220 to 240 Vac, 50 / 60 Hz.

No voltage regulation setting is necessary.

• As with all pieces of precision electronic equipment, follow the next rules

when using the ARGOS :

- Do not subject the equipment to shocks or vibration.

- Avoid extreme temperatures and humidity.

- Avoid use in a dusty environment.

- Allow adequate ventilation when in operation.

REPLACING THE MAINS FUSE

• Unplug the mains cord.

• Gently lift the lid on the right side of the mains plug. Be cautious, the fuse-holder can not be

removed. The first compartment is used for a spare fuse, the second one, nearest to the

set, contains the active fuse.

• Replace the fuse according the list below :

T40mA (slow blow fuse) Wickmann 19195 for 220 / 240 Vac. (Europe)

T40mA (slow blow fuse) Bussmann S504 for 220 / 240 Vac. (Europe)

• Push back the fuse-holder.

GENERAL CARE

• Avoid exposing the ARGOS to a dusty or smoke-filled environment.

• Clean the surfaces of the ARGOS with a dry, lint- free cloth.

Do not use spray cleaners, thinner or solvents. A mild detergent applied to a slightly

damp cloth may be used to remove stubborn stains or grease marks.

WARMUP AND CONDENSATION

If the ARGOS is brought into a warm room from a cold environment, internal condensation

may occur. Allow between 1 and 2 hours for the unit to acclimatise before putting it into oper-

ation.

ARGOS - USER MANUAL

Installation and precautions.

ARNING :

There are no user-serviceable parts inside the ARGOS.

Do not disassemble the ARGOS.

Refer to an Apex service centre for any repairs or adjustments.