User`s manual

Operation 2011-09-30
6
File position
Memory Ba
r
starts flashing
Flashes
Settings
1. Select Memorized Flash Bar
Method
Press Set Switch. Each press of the Set Switch will change
the memory selected in the sequence 01 to 02 to 03 and then
back to 01 again. The Flash Bar set for each memory will
appear when that memory is selected. The memory
selected when the unit is turned off is the one that will be
selected when is it turned back on again.
2. Set the Flash Bar
The Flash Bar can be set anywhere from 2 to Apex (0).
Use it as an estimate of the canal’s working length.
Method
When the file is not inserted, hold down the Power Switch
and then press the Set Switch at the same time. Each press
of the Set Switch will move the Flash Bar one bar towards
the Apex. The position will be automatically memorized.
NOTE
The Flash Bar cannot be set beyond the Apex.
3. Memory Bar
The Memory Bar can be set anywhere up to APEX.
The Memory Bar can be set during treatment to mark a point
of interest inside the canal such as the beginning of a curve, a
certain distance from the apex, or the point to change file
size for enlargement.
Method
Insert the file up to the desired point and then press the Set
Switch. This will cause another bar to flash on and off at a
slightly slower speed that the main Flash Bar. This will not
change the point where the alarm is activated.
WARNI N G
The Memory Bar should only be used as an estimate. You
may need to change it during enlargement and cleaning. If
there seems to be some problem, stop using the instrument
immediately.
NOTE
• The Memory Bar cannot be set beyond the Apex.
• The Memory Bar can be set at a different point for each of
the 3 memories.
• The Memory Bar will stay wherever you set it until the
Root ZX mini is turned off, but it will not be memorized.