User's Manual

6–33
10004880 Rev. D1
Chapter 6. The Web GUI
Status Pages
The Web GUI include the following status pages:
• The System Status page, shown in Figure 6-31, identifies the PacketWave 200, its
software and hardware, and its current operational status.
•The Ethernet Status page, shown in Figure 6-32, shows the status, speed, and
duplex mode of the Ethernet link to the subscriber’s computer or network.
• The Radio Status page, shown in Figure 6-33, provides information and status
regarding the PacketWave 200 radio.
• The Link Status page, shown in Figure 6-34, provides information about the wire-
less link between the subscriber equipment and the base station.
• The PPPoE/PPP Status page, shown in Figure 6-35, provides information about the
PPPoE/PPP session. This page will only be available only if NAT and PPPoE have
been enabled.
System Status and PPPoE/PPP Status are available at both ISP and Subscriber levels;
Ethernet, Radio, and Link Status are available at the ISP level only.
Figure 6-31 System Status Page