User's Manual
Table Of Contents
5–9
10004880 Rev. D1
Chapter 5. The PacketWave AIM
13. In the Configuration Window, click on the Advanced tab to view additional config-
uration options as shown in Figure 5-7. Configure the following parameters as
appropriate:
a. In the BSU ID field, enter the name of the PacketWave 200’s Base Station
Unit, as specified in the configuration of the BSU. Remember that the BSU ID
is case-sensitive.
CAUTION: Since the BSU and SU both use the BSU name and wireless port in the
signal scrambling algorithm, the BSU and SU will not be able to commu-
nicate if the BSU name is not entered correctly.
b. Select the Polarization/Antenna Diversity from the drop-down menu.
NOTE: If you are unsure about what to select, the default (Vertical) will probably
be an appropriate choice.
c. Use the drop-down menu to select the Channel Width. If you are unsure, stick
with the default selection.
d. For VLAN applications, specify the Management VLAN ID and Management
VLAN priority. Usually, the Management VLAN ID should be the same for the
SU and BSU. If you leave the value at the default of 0, the SU will automati-
cally learn and use the BSU’s Management VLAN ID.
NOTE: VLAN configuration is performed primarily using the Configuration Man-
ager. Only the VLAN management ID and priority can be set locally using the AIM.
Figure 5-7 Configuration Window: Advanced