User's Manual

Chapter 5. The PacketWave AIM
5–8
10004880 Rev. D1
c. In the BSU’s WSS number field, select the wireless port with which the SU
will communicate.
d. If local IP configuration is chosen, specify the appropriate IP address, Subnet
mask, and Default gateway for the PacketWave 200. Alternatively, uncheck
the Use local configuration box to enable the PacketWave 200 to receive IP
configuration from the BSU using DHCP.
12. If Automatic Frequency Selection (AFS) is desired, you can click on the Configure
other frequencies button to open the AFS Frequencies window shown in Figure 5-6.
AFS will be enabled if you specify at least one alternate frequency. To make antenna
aligning easier, however, Aperto recommends that you specify additional frequen-
cies for the PacketWave 200 via the Web GUI after antenna alignment has been per-
formed. (See Wireless Interface Configuration on page 7-13.)
CAUTION: Enabling AFS during initial setup using the AIM will mean that the
PacketWave 200 will be likely to switch frequencies every 2 minutes dur-
ing antenna alignment, making the procedure very difficult.
Figure 5-6 Configure Other Frequencies Window