User's Manual

5–5
10004880 Rev. D1
Chapter 5. The PacketWave AIM
5. The Installation Option Window will be displayed, as shown in Figure 5-3. This win-
dow presents five AIM modes:
• Setup provides the complete AIM functionality: basic configuration, antenna
alignment, and throughput testing. To use this option, proceed to the next
section, Basic Configuration.
• Continue with Setup is used for antenna alignment when basic configuration
has already been completed. (Use this option if antenna alignment was not
successfully completed for a preconfigured PacketWave 200.) To use this
mode, follow the instructions under Re-aligning the Antenna (Continue with
Setup Mode) on page 5-15.
• Link Status displays graphs of the status of the wireless link. To use this
mode, follow the instructions under Viewing Status of the Wireless Link (Link
Status Mode) on page 5-16.
• Test only provides direct access to the ping and throughput tests. To use this
mode, follow the instructions under Running a Non-Destructive Test (Test
Mode) on page 5-18.
• Provision provides access to the basic configuration without proceeding to
antenna alignment; it allows pre-provisioning of the unit prior to installation,
and enables the audio auto-alignment feature described in Chapter 4. To use
this mode, follow the instructions under Pre-provisioning a PW200 for Later
Installation (Provision Mode) on page 5-19.
Figure 5-3 Install Option Window