User's Manual

Chapter 4. Subscriber Equipment Installation
4–4
10004880 Rev. D1
To mount an Outdoor Unit on a pole using the standard bracket shown in Figure 4-3:
1. Locate the mounting holes for the standard bracket on the back of the ODU. There
are two sets of holes, allowing the mounting bracket to be oriented vertically or at
45 degrees. Choose the best orientation, making sure the RJ45 connector will be at
the bottom of the ODU when it is mounted.
2. Attach the L-bracket to the back of the ODU using the three screws provided.
3. Remove the bolt that holds the clamp closed.
4. Position the clamp around the pole in the desired location. Install and tighten the
clamp bolt to secure the clamp to the pole.
5. Position the ODU with attached L-bracket so that two bracket bolts on the clamp fit
through the mounting hole and slot on the L-bracket. Using the washers and nuts
provided, secure the L-bracket to the clamp.
6. Adjust the azimuth and elevation orientation of the radio/antenna as necessary by
loosening the appropriate nuts, repositioning the ODU, and tightening the nuts.
Figure 4-3 Standard ODU Mounting Bracket
L-Bracket
Pole Clamp