User's Manual

4–1
10004880 Rev. D1
4
Subscriber Equipment Installation
Installing the PacketWave 200 Series Subscriber Equipment consists of the following
steps:
1. Determining the locations for the Interface Box and Outdoor Unit (ODU).
2. Mounting and grounding the ODU.
3. Installing the Ethernet cable between the Interface Box and ODU.
4. Optimizing the direction of the antenna using the audio auto-alignment mode.
5. Connecting the Interface Box to the subscriber’s computer or LAN, and to AC power.
6. Configuring the subscriber’s PC or LAN.
7. If the audio auto-alignment mode was not used or was not successful, using the
Aperto Installation Manager utility to optimize the direction of the antenna.
Connectors on the Interface Box and Outdoor Unit are shown in Figure 4-1 and Figure 4-2,
respectively.
NOTE: Connectors and/or markings on some units may be slightly different in
appearance from those shown in the figures.