User's Manual

2–7
10004880 Rev. D1
Chapter 2. Overview
• PPPoE Client — PacketWave 220 and 230 models include a built-in PPPoE (PPP over
Ethernet) server.
PacketWave 200 LEDs
The LEDs on the Outdoor Unit and Interface Box provide operational information as
described in Table 2-A.
SNMP
Each PacketWave 200 includes an SNMP agent supporting the following MIBs:
• SNMP MIB (RFC 1157)
• MIB II (RFC 1213)
• Aperto private MIB
The complete MIBs are provided on the PacketWave CD, and are available on the Aperto
Web site,
www.apertonet.com .
SNMP can be used to read configuration, status, and performance data from Subscriber
Units. In addition, SNMP can be used to change some configuration parameters (those
which can be changed via the Web GUI), and to upload the configuration changes to the
TFTP server (if the TFTP server is configured to accept uploads).
The SNMP agents support trap reporting. Trap-reporting parameters can be specified via
the Configuration Manager and the Web GUI as well as via SNMP.
Table 2-A PacketWave 200 LEDs
LED Indications
Outdoor
Unit
Left Wireless Tx: Blinks on Wireless transmit activity.
Middle Wireless Rx: Blinks on Wireless receive activity.
Right On when Ethernet link is up; Off when it is down.
Interface
Box
ODU Port, left On when the Interface Box is powered on.
ODU Port, Right On when power is provided to the Outdoor Unit.
LEDs for the LAN port on the Interface Box are always off.