User's Manual

Appendix D. Command Line Interface (CLI)
D–2
10004880 Rev. D1
6. When you are finished with the CLI, end the Telnet session by entering the killTelnet
command or simply closing the Telnet application.
NOTE: One should type the command followed by an enter key. Then type the
“?” followed by an enter key. This will produce the desired effect.
Commands
Subscriber Unit CLI commands are defined in Table D-A. All commands are case-sensitive.
Error Messages
Error messages which may be returned by the Subscriber Unit CLI include the following:
• Error: Bad Command — command has been entered incorrectly.
• Error: Invalid Parameter — command has been entered incorrectly.
• Not applicable for SU — command applies to BSU CLI only.
• Passwords are not the same — when setting a password, two password entries do
not match.
Table D-A Subscriber Unit CLI Commands
Command Function
killTelnet Causes the CLI to terminate all current Telnet sessions connected at
port 5000.
reboot Reboots the Subscriber Unit.
set dhcpServer Does not apply to Subscriber Unit.
set vlan Sets vlan parameters.
set debug_passwd
set isp_passwd
set subs_passwd
These commands set passwords for Debug, ISP, and Subscriber logon.
CLI prompts for password to be entered twice (Enter Password:, then
Confirm Password:). New password is set only if the two entries are
identical, including case. Password cannot be set for higher logon level
than current logon.
show dhcp_server Shows the DHCP parameters, including IP address, subnet mask, and
gateway, TFTP servers, and config file name.
show config file Displays the Subscriber Unit’s configuration file in text format. File is
displayed one screen at a time; CLI prompts for key to be pressed to
display next screen.
show config frequency port 1
show config frequency all
Either command shows the center frequency for the Subscriber Unit’s
wireless port. The center frequency unit is 100 Hz; add two zeros for
frequency in Hz.
show config su_local_cfg Does not apply to Subscriber Unit.
show config vlan Shows the management VLAN parameters.
show status system Displays a broad range of system parameters.