User's Manual

D–1
10004880 Rev. D1
Appendix
D
Command Line Interface (CLI)
Each Subscriber Unit includes a simple command line interface (CLI) accessible via telnet.
The CLI is intended primarily for troubleshooting and debug use under direction of Aperto
personnel.
Accessing and Using the CLI
To access and use the Subscriber Unit’s command line interface:
1. Telnet to the Subscriber Unit’s IP address.
2. At the Login: prompt, enter the desired logon level: ISP or Subscriber. (There is also
a Debug logon level, which is reserved for Aperto use.)
NOTE: All CLI entries, including user name and password, are case-sensitive.
3. At the Password: prompt, enter the correct password for the specified logon level.
The CLI uses the same passwords as the Web interface. The default passwords
are isp and subscriber (case-sensitive). Passwords can be changed via the
WaveCenter Configuration Manager, the Web GUI, SNMP, and the CLI.
4. When the CLI# prompt appears, you are in the CLI.
a. For a list of commands, type ? (the ? will not appear on the screen; pressing
[Enter] is not necessary). The CLI will respond with a list of the available com-
mands groups.
b. To see the specific commands in a group, type the group name followed by ?
(again, the ? will not appear, and pressing [Enter] is not necessary).
c. To display information about the use of a specific commands, including com-
mand parameters, enter the command followed by ?.
5. If there is no activity on a connection for 30 minutes, the CLI will disconnect.