User's Manual
Table Of Contents
5–5070-20000330-01 Rev A
C
HAPTER
5. I
NDOOR
U
NIT
I
NSTALLATION
Powering Up the Indoor Unit
WARNING: For the PacketWave 100 Series Indoor Unit, use an outlet that con-
tains surge protection and ground fault protection, or use a surge pro-
tection device. This will protect the Indoor Unit and equipment
connected to it from damage resulting fron ac current surges, light-
ning, etc. For complete protection, all connections to the Indoor Unit
(i.e., from radio/antenna and PC/hub) should be connected to a surge
protection device. To ensure the best signal, use surge protectors
designed for the the specific application
To apply power to the Indoor Unit:
1. Plug the power cord into the POWER connector on the Indoor Unit, as illus-
trated in Figure 5-4.
2. Plug the power cord/transformer into a surge-protected ac outlet.
The Indoor Unit does not have an on/off switch; to turn the unit off, disconnect power
at the power outlet.
NOTE: The Outdoor Unit receives power from the Indoor Unit via the coaxial radio
signal cable.
Figure 5-4 Indoor Unit Power Connection