User's Manual

5–3070-20000330-01 Rev A
C
HAPTER
5. I
NDOOR
U
NIT
I
NSTALLATION
I
NSTALLATION
P
ROCEDURE
Installation of the Indoor Unit involves placing the unit in the desired location, con-
necting radio/antenna and local Ethernet cables to the rear panel, and applying power.
Position the Indoor Unit as desired.
WARNING: For proper cooling, the Indoor Unit must be installed in the
upright position, with adequate air flow around and through it.
Connecting Radio/Antenna Cables
To connect the radio antenna to the Indoor Unit
1. Locate the radio signal cable. If the cable does not already have one, install a
male F connector on the end of the cable.
2. Attach the cable to the RADIO RF connector on the Indoor Unit as illustrated in
Figure 5-2.
The Radio Control interface of the Indoor Unit has the same physical appearance
as the 10/100Base-T interface. Make sure you connect to the right one.
3. Locate the radio control cable. If does not already have one, install a male RJ45
connector (plug) on the end of the cable.
4. Attach the cable to the RADIO Control connector on the Indoor Unit as shown
in Figure 5-2.
5. Dress the indoor portions of the radio cables as desired.
Figure 5-2 Indoor Unit Connections from Outdoor Unit
To radio/antenna’s
Radio RF connector
To radio/antenna’s
Radio Control connector