User's Manual

5–1070-20000330-01 Rev A
5
I
NDOOR
U
NIT
I
NSTALLATION
In most cases, the installation of the Outdoor Unit (see Chapter 4) should be per-
formed before the installation of the Indoor Unit. For convenience during the instal-
lation of the Outdoor Unit, the Indoor Unit should be temporarily placed close to the
Outdoor Unit to facilitate antenna alignment. When the installation of the Outdoor
Unit is complete, the Indoor Unit can be moved to its permanent location.
I
NSTALLATION
R
EQUIREMENTS
You will not need any tools to install the Indoor Unit. Cable and power connections
are made to the Indoor Unit’s rear panel, illustrated in Figure 5-1.
The subscriber must have either an Ethernet LAN or a computer with an Ethernet
interface. You will need to supply an Ethernet cable of sufficient length, with an RJ45
plug on each end. Use a straight cable for connection to a hub or router, or a crossover
cable for connection to a PC.