User's Manual
Table Of Contents
C
HAPTER
4. O
UTDOOR
U
NIT
I
NSTALLATION
4–6070-20000330-01 Rev A
To properly ground the Outdoor Unit:
1. Locate the ground point on the back of the Outdoor Unit. It is the screw in the
lower left corner (the unpainted corner) of the mounting bracket support
attached to the rear of the Outdoor Unit. (See Figure 4-4.)
2. Secure a lug to the grounding screw on the Outdoor Unit.
3. Provide a proper grounding conductor (NEC Section 810-21) long enough to
reach from the Outdoor Unit to the earth ground.
4. Attach one end of the conductor to the lug installed in step 2.
5. Connect the other end of the grounding conductor to an appropriate earth
ground using a grounding clamp.
If you install a grounding electrode separate from the power service grounding
electrode system, connect the separate electrode to the grounding system in
accordance with the National Electrical Code (NEC) and local electrical
codes.
Figure 4-4 Location of Grounding Screws on Outdoor Unit (Radio/Antenna)
Ground Connection
Point — Attach Lug Here