User's Manual

CHAPTER 4. OUTDOOR UNIT INSTALLATION
4–4070-20000330-01 Rev A
Figure4-2 Connections to the Outdoor Unit (Radio/Antenna)
Control Connection
The control cable should be shielded outdoor-rated Cat 5, terminating with an RJ45
male connector (plug) at each end. The cable should be outdoor-rated, and may be up
to 165 feet (50 m) in length.
1. Obtain an appropriate length of cable, and run it from the Indoor Unit to the
Outdoor Unit. Include a service/drip loop as appropriate.
2. Place the supplied rubber boot over the radio/antenna end of the cable.
3. Install an RJ45 male connector on the radio/antenna end of the cable.
4. Plug the cable into the RJ45 socket on the Outdoor Unit as shown in
Figure4-2.
5. Put the rubber boot in position to protect the R-J45 connection and secure it in
place with a cable tie.
6. Dress the outdoor portion of the cable as appropriate.
7. Seal the entry of both cables to the building as appropriate.
Radio RF connector
To Indoor Unit’s
Radio Control connector
To Indoor Unit’s