User's Manual

4–1070-20000330-01 Rev A
4
O
UTDOOR
U
NIT
I
NSTALLATION
In most cases, the installation of the Outdoor Unit should be performed before the
installation of the Indoor Unit (see Chapter 5). For convenience during the installation
of the Outdoor Unit, the Indoor Unit should be temporarily placed close to the Out-
door Unit to facilitate antenna alignment. When the installation of the Outdoor Unit
is complete, the Indoor Unit can be moved to its permanent location.
I
NSTALLATION
R
EQUIREMENTS
You will need the following tools and supplies when installing the Outdoor Unit:
• Drill (for cable entry through walls, etc.)
• Phillips screwdriver
• Wrench (7/16 inch)
• Cabling tools
• Spare radio signal and control cables with connectors (each 30 feet or longer)
• Cable ties, staples, or clamps for dressing cables
• Silicone sealant
You will also need the following cables and connectors:
• Coaxial cable (quad shield) and two male F connectors
• Shielded Cat 5 cable (outdoor rated) and two RJ45 male connectors
• Ethernet cable with RJ45 male connectors (straight-through for connection to
hub, or crossover for connection to computer)