User's Manual
Table Of Contents
1–3070-20000330-01 Rev A
C
HAPTER
1. Q
UICK
S
TART
G
UIDE
Step 4. Initialize the Subscriber Equipment
A. Connect the power cable between the Indoor Unit and a wall outlet.
B. Perform antenna alignment procedure (see addendum on this subject).
C. Afterthe antenna is aligned, move the Indoor Unit to its permanent location.
WARNING: For proper cooling, the Indoor Unit must be installed in the
upright position, with adequate air flow around and through it.
D. Use the permanent radio signal and control cables to connect the Outdoor Unit to
the Indoor Unit.
- Radio signal cable (quad shield coaxial, male F connectors) — between
Radio RF connectors on the Outdoor and Indoor Units.
- Radio control cable (shielded outdoor Cat 5, male RJ45 connectors) —
between Radio Control connectors on the Outdoor and Indoor Units.
Step 5. Configure Subscriber Hosts
A. Connect the subscriber’s computer(s) to the 10/100Base-T interface on the Indoor
Unit, using a straight Ethernet cable for connection to a hub or a crossover Ether-
net cable for connection directly to a computer.
B. Typically, the only other thing necessary to connect a subscriber host computer to
the PacketWave network and beyond is to configure the host’s TCP/IP to obtain
its IP address using DHCP. Instructions should be available using the computer’s
online help