User's Manual

Chapter 5. The PacketWave AIM
5–14
10004880 Rev. D1
e. This test may take a few minutes to complete, depending upon the signal
characteristics. If you are not interested in the throughput test, or if the
throughput test takes more than 10 minutes, click on the Stop button.
f. When the throughput test is finished or stopped, the window shown in
Figure 5-16 is displayed, showing results of the ping and throughput tests.
These results and RF transmission results are recorded in a text file with
the name of the IP address, in the directory in which the AIM application
is loaded (normally C:\aim). Each time the Setup or Test function suc-
cessfully executes, this file is updated.
.
Figure 5-16 Installation Results Window
23. It is important to check the RF and IP transmission results to see if you have the
best possible wireless connection. If the results are not acceptable, perform the
steps described under Re-aligning the Antenna (Continue with Setup Mode) to
repeat the alignment process:
24. If you are ready to close the AIM, click on the Exit button of the Installation Results
window. The AIM will prompt for confirmation that you really want to exit.